VETERINARY Bunny-5
VITAL SIGNS MONITOR
THE 1ST VITAL SIGNS MONITOR VETERINARY FOR VETERINARIAN IN THE WORLD
The 1st Genuine Veterinary Monitor ONLY FOR Vet
Oxygen saturation of 10 adult dogs weighing 5 to 25kgs were measured.
The average values were compared after measuring total 10 dogs every 10minutes for total 80 minutes.
Tissue oximeter (Standard value)
NIBP COMPARISON TEST
NIBP was measured from 10 adult dogs under anesthesia weighing 5 to 25kgs.
After measuring 5 times, without using the highest and the lowest values into calculation, the intermediate 3 values were chosen into calculation
NIBP
An anesthetized patient�s blood pressure should be regularly monitored.
The vet Patient Monitor uses the oscillometric method to obtain systolic, diastolic, and mean non-invasive blood
ices
- A patient�s movement during measurement may cause inaccurate results.
- Do not use with any other respiration equipment. Choose the cuff type which is appropriate to the patient
- In the event a good blood pressure reading is not recorded on the initial cycle, the monitor will attempt a second reading. If this fails, the unit will revert to standby mode. Check the BP line and cuff condition as well as size and placement.
- Wrapping the cuff too tightly or too loosely on the measuring site may cause errors in the value.
SpO2
For stable measurement, minimize patient movement.
Notices
If results are not available at all or are inaccurate, please check the following:
- Reposition the sensor or change to another part of the body to correct poor or inaccurate readings.
- Check if the sensor is properly placed.
- The sensor site should be clean and free of oils and lotions.
© 2019 by AKAI Med. Kowloon, HONG KONG